How to Properly Snake a Clogged Pipe
2/14/2020 (Permalink)
If you have tried fixing your clogged drain in Prairie Village, KS with conventional cleaning products or a plunger and the drain is still stopped, it is time to give a drain auger a try. Sometimes called a drain snake, this device has a heavy-duty steel coil cable that is pushed into the drain to break up the blockage and pull it out. Because the cable is made of flexible steel, it can bend around the curve of the pipe to go much deeper than an inflexible gadget can. There are many options available to purchase online, including manual and electrical models, but you can also rent one quite cheaply from a rental center. There are a few easy steps to follow to unclog your drain.
Steps in Using a Drain Snake
Place the snake into the opening of the drain and turn the drum handle. This allows the snake to start moving into the drain.
Keep cranking on the handle until there is some resistance. At this point, you may need to push a bit harder to allow the snake to go around the pipe curve. Just be careful not to apply too much pressure or it could cause a pipe break.
After going around the curve, the snake will hit up against the obstruction. If the clog is in one solid piece, the snake head will either break it into pieces or it will catch on the tip of the snake. Pulling the snake out will pull the clog out along with it. Any smaller pieces that had broken off the larger clog can be flushed down the drain.
Let the water run at full power for a couple of minutes. This will ensure that the drain is no longer clogged.
Most clogged drains can be fixed without having to call a plumber. Using a drain snake will make the job easy.